Little metal adapters that go on the fuses to allow you to tap into the fuse box. ![]() You have to tap into a switched power source at the fuse box. Mounting in the nose Wiring the lights I bought the stock fog light switch from the dealer for $70 so it would look factory. I mounted the lights by drilling two small holes and using small self Running Light controller and skip the cockpit (just follow the cable from the lever under the dash to the firewall. I was able to get mine through at the hood opening cable The toughest part of installing fog lights is getting the So use your fog lamps when necessary and slow down to give yourself enough time to react to what those lights reveal.How To Install Fog Lights By Rob Robinette Remember, the primary goal is to see better in the fog. But getting home in one piece is even cooler. When you’re finished, step back and enjoy this simple upgrade. Then, adjust the lights so the top of the fog beam pattern is about four inches below the lamp center.Place a horizontal mark on the wall at that height.Measure the distance between the center of the fog-light beam (on the vehicle) and the ground.Park your vehicle on a level surface, 25 feet from a wall.To maximize the benefit of fog lights, they should be properly aimed. Trim pieces in the kit go on the outside to cover up your handiwork. It’s okay if the holes are somewhat ragged. Consult your owner’s manual or online videos about how to do this.Īfter choosing the best location for the lights, in the cover, cut holes slightly larger than the lights. If you are going to install the fog lights in the bumper area, the front bumper cover will most likely need to be removed. Trucks and SUVs, sometimes have a grille mount, making things easier. But that leaves them vulnerable to curbs and errant bumps in the road. The job is easier if the lights mount under the bumper. When the light is positioned lower, more of the ground will be lit. Aim for about 10 to 24 inches above the road surface and below the center of the headlights. This fog light fits into an existing pod.įog lights work best when mounted on or below the bumper. That ensures you won’t have a dead battery because the fog lights were left on.Īfter the wiring is complete, secure your work with plastic ties. They connect to the relay and the battery or an empty switched fuse location-one that only works with the ignition on. You can probably attach the ground wires to existing screws. Black is ground, which goes to any unpainted area. The color-coded wires from the switch connect through the firewall to the coded wires on the lights.If there are no holes, you can drill one, but use a rubber grommet to seal it as effectively as possible. You may have to get on your back to locate a hole, and remove some interior panels and trim. ![]() Then run the wiring through one of the dedicated holes in the firewall. Mount the switch in the car in an out-of-the-way location.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |